33” Rear DI Not in an enclosed box
Posted: 09 January 2011 09:47 PM   [ Ignore ]
Avatar
Rank
Joined  2008-12-20
Total Posts:  66
New Member

Finally after a long pause my table prototype is up and running well.  I stopped because I was frustrated with blob tracking.  Finally decided to try again and buy some rear projection acrylic(7d006), It made all the difference in the world.  I am going to use the post as I tear the ting apart and rebuild it with beter finish and tighter tolerances.  But I thought I would start with a few picturs of it as it is now.

Image Attachments
CIMG6745.JPGCIMG6745.JPGCIMG6746.JPG
Profile
 
 
Posted: 10 January 2011 03:56 AM   [ Ignore ]   [ # 1 ]
Avatar
Rank
Joined  2009-10-21
Total Posts:  11
New Member

Good job Jason!

i’m probably going to switch to 7d006 too, but i have one q: what is that big ir-lamp you have there?
tia!

--
brutoblo

Profile
 
 
Posted: 10 January 2011 07:32 AM   [ Ignore ]   [ # 2 ]
Avatar
Rank
Joined  2008-12-20
Total Posts:  66
New Member

They are some that I picked up on ebay.  They are very bright but they are very noisy.  I am in the middle of replacing them with the little silver one next to them.

Profile