is this project possible? 
Posted: 20 February 2012 12:17 PM   [ Ignore ]
Avatar
Rank
Joined  2010-07-14
Total Posts:  59
New Member

I got an assignment to build a counter bar which dimension is 80x40x100cm, the project area is 80x40cm (2:1 ratio), REAR DI will be applied on this box with ST Projector. The issue I found was the projected area (80x40cm) didn’t fit with any type of projector (ratio), is there any solution to make the resolution to fit this format? or is there any work around solution? or I used to think that just project the normal ratio to the surface then ignore the exceed portion, but this would be an issue when calibrating on CCV.

HUHHHHH. GUYS, guide me please

Image Attachments
bar.jpg
 Signature 

MY GEARS........

Rear DI Table:
Acrylic 10mm
Rear Projection Film
Benq515Shortthrow
PS3EYE
IR Illuminators
CCV1.3MOD
HIDDriver

Profile
 
 
Posted: 21 February 2012 12:49 PM   [ Ignore ]   [ # 1 ]
Avatar
RankRankRankRankRankRank
Joined  2008-09-12
Total Posts:  2225
Dedicated

You can change the bounding box size in CCV to accommodate any size (and theoretically shape) screen.  Just follow the instructions on the CCV calibration screen during setup.

 Signature 

MT Website - A Collection of the Most Relevant Multitouch Info From These Forums
Multitouch Blog
Multitouch Parts Store - Buy Infrared Touch Frames (No Camera Needed!), Complete Modified Cameras and DIY Upgrade Kits, m12/CS Mounts, m12/CS Lenses, Infrared Lasers, LEDs, etc

Profile