I am a beginner in terms of this kind of projects, I read different kinds of
multitouch techniques and i came across to the project of “How to make a cheap multitouch pad”
my 1st problem is that the movement of my calibration is not even moving then i tried using
touch lib but still no response in my monitor
here are the snap shots
in this figure, i dont even track my finger tip..
I used touch lib but still I dont even know why does it look like that
and this is my set up
kindly point out some corrections..
do I need to enclose it tightly? is my cardboard to high?
and the placement of my surface is GLASS-PAPER..