Hey. EndLighten is not very good with FTIR-setups and way to expensive for that anyway, since you dont need it. the only setup you will actually need Endlighten is DSI.
Have a look in the wiki section!
thank you for the reply.
i’m sorry, I not explained well my question…
I decided to build the multitouch --->SDI -----> with lcd monitor.
If doesn’t work well and if is it possible, i will transform it in FTIR --->maintaining the same plexiglas…
otherwise will replaced the Endlighten plexiglas.
...for now… neither.
I’m deciding wich to buy .
The first thing I have decided is to build the multitouch with Lcd via SDI.
therefore ,The Endlighten acrylic is the better choice…
but, if there possibility to change SDI in FTIR ( in simple mode) for experimented another way...it would not be bad !
for now i have this stuff :
- 100 Ir Led Osram 485 + resistors
- Lcd Asus vw222
- Philips webcam spc 900 ---> IR filter removed + IR band-pass filter
- Acrylic .... ?
yes, do so and actually, you can do two - one DSI screen and one FTIR screen, but bear in mind, on FTIR, if you want to have good dragging, you need to make a compiliant surface over the acrylic, which will be not comfortable to touch without some more protections film over it. When I did my first FTIR table, I was using Projector and there was a Rosco Grey projections film on the top, over the silicon compliant layer,for LCD - projections surface is useless..
and actually, you can do two - one DSI screen and one FTIR screen, but bear in mind, on FTIR, if you want to have good dragging, you need to make a compiliant surface over the acrylic, which will be not comfortable to touch without some more protections film over it. When I did my first FTIR table, I was using Projector and there was a Rosco Grey projections film on the top, over the silicon compliant layer,for LCD - projections surface is useless..